Tips, Tips for successful vacuum packaging, Sealing a bag – FoodSaver V845 User Manual

Page 5: Removing air from a bag

Advertising
background image

Tips

Tips for Successful Vacuum Packaging

For more usage tips and safety information, please refer to the FoodSaver Reference Guide or visit our website at www.foodsaver.com.

Sealing a Bag

Make sure you’ve placed the bag in the proper

place.

When making a bag from a roll, make sure end

of cut piece is on Sealing Strip

(L)

, not over rubber

gasket

(M)

or in Vacuum Channel

(J)

.

Prevent moisture or liquid from being pulled into

the Vacuum Channel or trapped in the seal.

Either

pre-freeze moist foods such as raw meat for 1-2
hours before vacuum packaging, or place a folded
paper towel between food and end of bag to absorb
excess liquids. Just be sure to leave at least 3 inches

between paper towel and end of bag so that bag
seals properly with paper towel inside.

Make sure the Seal Control Switch (G) is set to

Vacuum and Seal or to Vacuum and Extended Seal.

Make sure you give appliance time to cool down.

Wait at least 20 seconds between seals. Under very
heavy usage, appliance will shut off automatically to
prevent overheating. If it does, wait 20 minutes to
allow appliance to cool off.

Removing Air from a Bag

Make sure you’ve placed the bag in the proper

place.

When vacuuming and sealing a bag, make

sure open end of bag is inside Vacuum Channel

(J)

.

Check for wrinkles in the bag along the Sealing

Strip

. Wrinkles in seal may cause leakage and allow

air to come back into bag. Check for wrinkles in bag
along Sealing Strip

(L)

before closing lid and vacuum

packaging. If you find wrinkles after sealing bag,
simply cut bag open and vacuum package again.

If motor runs for more than 30 seconds without

stopping,

you may need to adjust bag and try again.

If you are making the initial seal on a piece of bag
material with two open ends, make sure bag is placed
on Sealing Strip, not on black rubber gasket. If you
are vacuum packaging with a bag, make sure open
end is placed down inside Vacuum Channel and make
sure Accessory Hose

(A)

is not attached. If you are

vacuum packaging with an accessory, check Accessory
Hose in appliance lid and in accessory to ensure a
tight fit. Also make sure Seal Control Switch

(G)

is set

to

Vacuum and Seal

or

Vacuum and Extended Seal.

QS.825_845_GSS_v3.1 4/30/04 3:47 PM Page 5

Advertising
This manual is related to the following products: