Tiger V1 User Manual

Tiger lily products, Tlp, blinder, bel, escort, valentine, Got performance

Advertising
background image

Tiger Lily Products

TLP, Blinder, Bel, Escort, Valentine

PO Box 549

Tel

303-678-9101

Cel: 720-635-3931

Niwot, CO, USA 80544

Fax

303-678-9103

Cel: 720-298-0557

Email [email protected]
Web

www.1stRadarDetectors.com

Rated #1, 360 Degree, High Performance, PRS1-STi-360™ Prowler Remote™ System

PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2 -STi, PRS3-V, PRS3- STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999 -2008.

Got Performance

Best in Test

Radar, Laser & Photo

Countermeasures

V1 Install Instructions, V1 & Valentine 1 Programming, November 2007

V1 Remote Installation Instructions

1. Use J Hooks hardware to install Remote Kit behind grille of vehicle, on top of Ski Rack, or just under the

bumper, or in the bumper (if a fiberglass bumper is available). The higher the better the performance. Drill
holes on the outer flanges of the aluminum enclosure, left and right sides, use J Hooks to hold package to
desired surface. A bracket is provided.

2. If your vehicle is an SUV or pickup truck or larger, you can install under the bumper. If the install location is

good (typically just under the height of the bumper and approximately 18” back), the V1 will detect radar to
the front with excellent sensitivity and to the rear with reasonable sensitivity. Do not install too low due to
potential road damage to the V1 Remote, when parking or going over parking lot bumps.

3. The cable protruding from the Remote Kit is the rear of the kit facing the engine compartment.
4. If installed behind the grille, rear radar detection will be significantly reduced. Ensure no metal is in front of

the V1 Remote, and ensure V1 Remote is kept away from radiator to prevent heat damage. If installed
inside a front, foam core bumper, ensure no metal is in front of the V1 Remote.

5. Run the 14 foot cable into the cockpit and hook up according to electrical layout highlighted below. If the

cabling is ran differently than shown above, there will be no display on the Remote Concealed Display.

6. Call TLP on any questions you have or to order remote electronic display, audio control and cabling. The

Valentine One inside is a die-cast Magnesium enclosure, surrounded by a very sturdy Aluminum outer
enclosure.

Advertising