Troy-Bilt TB2BP User Manual

Tb2bp, Cycle backpack blower operator’s manual, Need help

Advertising
background image

IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.

Remove Unit From Carton

Assemble The Unit

Place a hose clamp over
the end of the Flex Tube
and slide the end of the
with the clamp on it over
the elbow tube. Tighten
the clamp screw.

Place a hose clamp over
the other end of Flex Tube
and slide the end over the
top end of the upper
blower tube. Tighten the
clamp screw.

Assemble The Unit

Loosen the 2 screws on
the throttle control. Move
the throttle control to the
position that provides the
best grip and tighten.

Mix thoroughly in separate
fuel can:
– 3.2 fl. oz. of 2-cycle

engine oil

– 1 gallon of unleaded

gasoline

NOTE: Do not mix directly

in fuel tank.

Press primer bulb 10
times
, or until fuel is
visible

Move choke lever to
Position 1.

Press down cruise control
to FAST position.

Crouch in starting
position.

Pull rope 5 times.

Move choke lever to
Position 2 .

1

1

2

Remove all contents from
the carton.

6

7

9

10

3

Insert the upper blower
tube into the lower blower
tube and twist the lower
tube clockwise unit it locks
into place.

Place unit on a level
urface and fill fuel tank.
DO NOT overfill.

8

4

Start The Unit

11

12

13

14

10 X

5 X

Starter Rope

Flex Tube

Throttle Control

On/ Off Switch

Lower Blower Tube

Nozzle

DIDN’T START?

Repeat these instructions.

IF the engine hesitates, return the choke lever to

Position 2 and continue the warm-up.

IF the engine does not start, go back to step 9.

IF the unit fails to start after 2 attempts, move choke

lever to Position 3 and pull rope until unit starts

Primer

Bulb

Move choke lever to
Position 3.

Continue to keep the
cruise control in FAST
position and warm
unit for
an additional 60 seconds
to complete warm-up. Unit
may be used during this
time.

16

17

Pull rope 3-5 times to
start engine. Keep the
cruise control in FAST
position and
allow unit to
warm up for 30 to 60
seconds.

15

Primer Bulb

Tools Required-

Phillips Screwdriver
T-20 Torx

®

Screwdriver

Insert the lower blower
tube into the nozzle and
twist the nozzle clockwise
until it locks into place.
Zip tie the throttle cable to
the elbow tube.

5

Upper Blower

Tube

Fuel Cap

Choke Lever

Cruise Control

1 Gallon

3.2 oz

40:1

SLOW

FAST

SLOW

FAST

Start The Unit

Spark Plug

TB2BP

2-Cycle Backpack Blower

Operator’s Manual

769-06202 P00

9/10

NEED HELP?

Call 1-800-828-5500 in U.S. or 1–800–668–1238 in Canada

ENGLISH — P

AGE 2

FRANÇAIS — P

AGE 5

ESP

AÑOL — P

AGE 9

Advertising