Pioneer DMP-555 - Manual (Page 22)

22
En
OTHERS: TROUBLESHOOTING
Error Message Display
When the DMP-555 player is unable to operate properly, an error code is displayed on the display panel. Check the error code displayed against the following table and take the
recommended action to correct the error. If an error code other than any of the error codes listed in the table below is displayed or if the same error code is displayed even after
corrective action has been taken, contact your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.
÷ Static electricity and other external effects may cause this unit to malfunction. In this case, set the POWER switch to OFF, then switch it on again after the disc has come to
a complete stop.
÷ This unit cannot playback unfinalized (partial discs) CD-R or CD-RW discs.
÷ This component is designed to play 12cm discs and 8cm discs with a commercially available adaptor, eccentrically shaped discs cannot be played since damage or malfunc-
tion may result.
÷ The BPM value measured by the DMP-555 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference is a result of differences in the BPM value
measurement method; not a result of a fault with the player.
CD PLAYER ERROR
Error code
E-7201
E-8301
E-8302
E-9101
Possible cause and first aid
Disc is dirty.
Disc has a crack.
Player cannot recognize that disc.
= Please try on another disc.
If player does well, a cause is in that disc.
Disc loading/unloading mechanism is out of order.
= If a disc is still in the inside of the player, please turn off a power first and carry out forcible ejection of
the disc (See page 5).
Description
TOC READ ERROR
START UP ERROR
PLAYBACK ERROR
MECHANICAL TIME OUT
CARD ERROR/CAUTION
Message
ERROR
FULL
NO CARD
NO TITLE
NO TRACK
NOT SDCARD
PROTECTED
READ ERROR
TOO SHORT
UNFORMAT
UNKNOWN
Possible cause
Card is broken.
This card has no or enough space to write/record.
Card is not inserted correctly.
Card detection switch is broken.
Title has not been written.
Title is written in two-byte character format.
That card is new one and there has been no download operation done.
Download operation failed.
All of the downloaded tracks are unsupported format.
Current Playlist is empty.
MultiMediaCards are able to be played but not able to write/record.
The card is another type of the SD memory card family.
The card is broken.
Write-protect switch of the card is locked.
The card is a Read-only type memory card.
Data in the card is broken.
The length of the track is shorter than the length of one beat.
That track is made for CUE sampling stuff.
Detected BPM value is too small by miscounting.
The card had been formatted uncorrectly.
There is no valid artist name for the track.
There is no valid album name for the track.
Description
There is something wrong.
This card is full of data.
There is no card available.
There is no valid title information.
There is no track available.
This card is not an SD memory card.
This card is protected from rewriting.
It is impossible to continue to read.
This track is too short to loop-play.
This card has not been formatted.
Artist is unknown.
Album title is unknown.