Volvo Penta D2-75 User Manual

Page 41

Advertising
background image

39

MS25S / 150S

Seawater system. Draining

If it is not possible to keep the engine compartment
free of frost, the seawater system must be drained to
prevent freezing damage.

Note that all the seawater must be drained. The type
of drainage must be adapted to the way in which the
engine is installed and any additional equipment that
is connected, for example sea water filter (2),
vacuum valve (8), silencer (7) etc.

WARNING! Risk of water penetration. Close the
sea cock before starting work.

IMPORTANT! If the boat is laid-up for winter or
the off season, the seawater system must be
instead flushed clean and protect against
corrosion according to the instructions in the
previous section.

Draining:

1. Close the seawater cock (1).

2. Remove the cover and sealing plate on the sea

water filter (2).

3. Remove the cover (3) from the seawater pump. Let

the water run out.

4. Open the drain cock (4) on the rear end of the heat

exchanger and drain the water off.

D2-75:
Open the drain cock on the charge air cooler (9)
draining the water.

5. Disconnect the hoses where indicated by the

arrows (5). Drain the hoses.

6. Open the drain plug (6) on the reverse gear oil

cooler and drain the water off. Close the drain plug.

7. Drain the silencer (7), the exhaust system and any

other additional equipment connected to the
seawater and exhaust systems.

8. Reinstall all hoses, the cover on the seawater

pump and the cover and sealing plate on the
seawater filter. Close the drain cock on the heat
exchanger.

D2-75:
Close the draincock on the charge air cooler.

9. Opened the seawater cock the next time the boat

is used.

WARNING! Check that there is no leakage in

the seawater system.

6

MS25

6

HS25

Maintenance: Seawater system

3

7

5

2

1

8

5

4

9

MS25 / HS25

7

2

1

3

8

6

5

4

9

7742957 - Downloaded from www.volvopenta.com 22/09/2008 11:33:23

Advertising
This manual is related to the following products: