Sensor adjust – Viper 5902 User Manual

Page 32

Advertising
background image

Configurations

29

© 2009 Directed Electronics. All rights reserved.

Placing the system into the remote pair mode

Open

1.

one or more of the vehicle doors.

Turn

2.

the ignition to the On position.

Press

3.

, release, then press and hold the Control button (on Con-

trol Center).
The control center LED begins to flash and the siren emits one

4.

chirp to confirm the system is in Pair mode, the Control button
can be released. The system will stay in Pair mode for 60
seconds or until the doors are closed or ignition turned off.
The siren will emit one short and one long chirp when it exits
remote pair mode.

Toggle

1. to

Remote Pair

and press the menu wheel, the

Remote

Pair

screen with on-screen instructions is displayed.

Press

2.

and

hold the

button. The remote’s LED flashes, then

the siren chirps, and remote tones play to confirm pairing. The

PAIRING SUCCESSFUL

screen is displayed before returning to the

Adjustments feature menu screen.
If the remote does not learn the system ID it displays the

3.

PAIRING FAILED

screen after the button is released before re-

turning to the Remote Pair screen. Press and hold the
button to try again. If the siren chirps but remote tones are not
played, Press and hold the

button to try again until the

tones are played. If the siren does not chirp shortly after the
remote LED begins flashing make sure the system is in remote
pair mode.

Sensor Adjust

Your Responder HD security with remote start system has a built in
shock sensor used to detect intrusion attempts on your vehicle. The
sensor sensitivity can be adjusted to optimize your vehicle’s detection

Advertising