Viper 5902 - Manual (Page 39)

36 © 2009 Directed Electronics. All rights reserved.
Full Silent Arm Protection
Sensor warn-away, Sensor full trigger and Point of entry activations
will only send messages to the remote, with vehicle light flash and
siren outputs defeated.
Sensor Warn-away Messages
When the remote receives a Sensor Warn-away message it emits 10
beeps (if on) and plays a sensor zone specific
WARN AWAY
anima-
tion once. Warn-away messages cannot be reviewed or displayed
in reports.
Full trigger Messages
A Full Trigger message generates a Full Trigger output of siren tones
and zone specific
TRIGGER animation for 15 seconds followed by an
alert that consists of 2 beeps per minute for 10 minutes.
To stop the output and alert, press a command button to perform a
command, or toggle the menu wheel. If the output is not stopped, the
next press or toggle of the remote control buttons or wheel replays
the zone specific
TRIGGER animation for review before returning to
normal operation.
Emergency Override
The following procedure disarms the system when a programmed re-
mote is not available. Number of presses__________
Turn 1. the ignition On.
Press 2. the control button on the Control Center the correct
number of times (the default is 1 press).
After a few seconds the siren output ceases and the system
3.
is disarmed.