Vermont Castings 1610 - Manual

Warming Shelf #0200,
#0210
Installation Instructions
for the
Encore NC Model 1450
Defiant NC Model 1610
Contents:
1, Warming Shelf (#0210) .......... 30002823, Defiant NC
or
1, Warming Shelf (#0200) ........... 30002477, Encore NC
2, Mittenracks ...................................................1601705
1, Bracket, Right .............................................30002479
1, Bracket, Left ...............................................30002478
1, Bracket, Dragon ...........................................1302220
2, Cap Screw 1/4-20 x 1/2” hex head ...............1201338
3, Cap Screw 1/4-20 x 5/8” hex head ...............1201372
3, Washers .......................................................1202473
4, SS,Soc 1/4-20 x 7/16 ...................................1200422
1, 1/8” Allen Wrench
Tool Required:
7/16” open-end wrench
Warming Shelves add versatility to your stove; they
keep foods warm at mealtime, and provide a convenient
spot to store a kettle or pan when you top-load your
stove.
The Warming Shelf is designed to hold up to 30
pounds. However, always place objects on a shelf
carefully to avoid sudden impact. Containers left on the
shelves or on the stove for long periods of time should
have water in them to prevent damage from overheat-
ing.
Take special care with stoves and shelves that are
enamelled, to avoid chipping the finish.
Each Shelf includes a pair of nickel-plated mittenracks
that are ideal for drying damp mittens, socks, dish tow-
els, etc. Do not leave combustible items unattended on
the shelves or mittenracks for extended periods of time,
however, as they may overheat.
30002488 8/08 Rev. 6
KT186
Warming shelf
parts
2/22/01 djt
KT187
Fig. 2 Attach brackets to threaded holes in top plate.
KT186
Warming shelf
parts
2/22/01 djt
Front of
Stove
Left Flat
Bracket
Right Flat Bracket
Dragon Bracket
KT186
Mittenracks
Fig. 1 Warming shelf parts.
Warming
Shelf
Levelling
Set Screw
Levelling Set Screw
The Shelf installation is completed in three stages. At-
tach the two brackets loosely to the stove, leaving the
screws loose enough to allow final adjustments. Then,
position the shelf and adjust the brackets so the shelf
fits correctly. Finally, tighten the screws.
Part 1. Attach the Brackets and the Shelf
1. Screw the levelling set screws into the bottom of the
flat brackets as shown in Figure 1.
2. Screw the flat brackets to the stove. Pass a 1/4”-20
x 1/2” hex-head cap screw up through each bracket
and into the threaded hole in the stove’s top plate.
(Fig. 2) Tighten the screws enough to secure the
brackets, but keep them loose enough for the brack-
ets to move slightly.
3. Attach the dragon bracket to the flat bracket at the
front of the stove using a flat washer under the head
of a 1/4”-20 x 5/8” screw. (Fig. 3) Tighten the screw
only finger-tight.