Williams Sound Multiple Charger CHG 1269A User Manual

Multiple charger instructions, Multiple charger case, model chg 1269a

Advertising
background image

C

HARGING

I

NSTRUCTIONS

Step 1:

Plug the power supply into an AC wall outlet. Plug the power connector into the jack on
the left side of the CHG 1269’s control panel.

Step 2:

Make sure the units you will charge are turned OFF. DO NOT attempt to recharge
disposable batteries.

Step 3:

Plug a charger cord into the charge jack on each unit.

Step 4:

When all units are connected, push down the “Press to Charge” button on the CHG
1269’s control panel. The red “CHARGE” indicator on the CHG 1269’s control panel
will light during charging.

Step 5:

The CHG 1269 will charge the units for about 16 hours, then shut off automatically.

Units may be fully charged before the green “DONE” indicator is lit. Units may be connected to
the CHG 1269 Multiple Charger for more than 16 hours without harm. Williams Sound
rechargeable 9 V and 6 V batteries can be charged on a daily or less frequent basis.

E

XPECTED

B

ATTERY

L

IFE

P

ER

C

HARGE

9 V Rechargeable (BAT 003): 8 hours for a Receiver or PockeTalker, 3 hours for a Transmitter.
6 V Rechargeable (BAT 021): 15 hours for a Receiver or PockeTalker, 10 hours for a Transmitter.

I

MPORTANT

R

ECHARGEABLE

B

ATTERY

I

NFORMATION

1.

Rechargeable batteries are shipped in a discharged condition. They must be charged for
12 - 14 hours before use. Follow the directions above to charge.

2.

Williams Sound 9 Volt products are designed for use with a NiMH rechargeable battery
(BAT 003) and matching charger (BAT 004, BAT 005, CHG 1269). This is the only type
of 9V rechargeable battery and charger we recommend. The BAT 003 has an 8.4 V
nominal voltage and 100mAh capacity, compared to 7.2V and 60 mAh for other types of
rechargeable “9V” batteries. The BAT 003 provides significantly longer battery life per
charge than lower voltage batteries. Williams Sound 6 Volt products are designed for use
with a special 6 V NiMH battery pack (BAT 021). The BAT 021 can be used with the
BAT 005 Single Charger or the CHG 1269 Multiple Charger. OTHER CHARGERS
SHOULD NOT BE USED.

3.

Do not mix batteries and chargers from different manufacturers. Using the BAT 003
battery with chargers designed for lower-voltage batteries can result in under-charging
and shorter battery life. Using the BAT 004, BAT 005, or BAT 012 Charger with low-
voltage batteries can result in over-charging and battery failure.

4.

The CHG 1269 Multiple Charger can charge 6 Volt or 9 Volt Williams Sound products.
6 Volt and 9 Volt units can be mixed in the CHG 1269.

5.

Do not dispose of batteries in fire. Do not open batteries - toxic chemicals inside.

Multiple Charger Instructions

Multiple Charger Case, Model CHG 1269A

© 2006, Williams Sound Corp. FRM 411F

Advertising