Samsung SCX-8030ND - Manual (Page 19)

Setting up the hardware_ 19
13. Make sure the two rubber pads (left side) and two plastic projections (right side) on the bottom of the DADF on both
sides touch the top of the machine as shown below.
• If you skip this step, it could cause originals to jam.
• If the gap is more than 0.5 mm (0.02 inch), adjust the screw on both sides as shown below until the gap is
smaller 0.5 mm (0.02 inch). You have to check all rubber pads and plastic projections.
14. Fit the plastic covers in the both hinges of the DADF.
scx_8040_install_english.book Page 19 Monday, August 30, 2010 4:23 PM