Wayne TSC User Manual

Submersible utility pump, Very important safety information

Advertising
background image

Submersible Utility
Pump

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.

© 2000 Wayne Water Systems

Operating Instructions and Parts Manual

TSC

Do not pump flammable or
explosive fluids such as gaso-
line, fuel oil, kerosene, etc. Do not use
in a flammable and/or explosive envi-
ronment. Pump only clear water.
Personal injury and/or property dam-
age will result.

Risk of electric shock! This
pump has not been tested for
use in swimming pool areas. Never
place pump in pools while people are
in the water.

Do not handle pump with wet
hands or when standing in
water or on a damp surface.

Risk of electric shock! This
pump is supplied with a
grounding conductor and grounding
type attachment plug. Use a grounded
receptacle to reduce the risk of fatal
electrical shock.

This pump con-
tains dielectric

motor oil for motor heat transfer.
Care should be taken when disposing
of this oil. Do not use this pump in
ponds or fountains because the motor
oil can be harmful to aquatic life.

2. Wear safety glasses at all

times when working with
pumps.

3. It is strongly recommended

that this unit be plugged into a
Ground Fault Circuit Interrupter
(GFCI). Consult a local electrician
for installation and availability.

4. Do not use the power cord or dis-

charge hose to carry or handle the
pump. Damage to the power cord
or discharge hose may occur. Use
the lifting ring supplied on the
pump.

351301-001 1/00

Installation and Operation

Always disconnect
electric supply
before attempting to install, service,
relocate or perform any maintenance.
If the power source is out of sight, lock
and TAG IN OPEN (OFF) POSITION to pre-
vent unexpected power application.
Failure to do so could result in fatal
electrical shock!

This unit is not designed for
use in septic tanks or under-
ground vaults to pump raw sewage or
effluents. Never use in hazardous or
explosive locations.

1. This pump has been designed to

attach to a standard garden hose.
Thread the female end of the gar-
den hose to the male discharge on
the pump.

2. To reduce leakage between the

pump and the hose, place a hose
washer (not included) on the gar-
den hose before installing to the
pump.

3. For best pump performance,

unwind the hose before starting the
pump. This will help remove any
kinks or binds in the hose and allow
the unit to pump with less
restriction.

4. Set the pump on a hard surface in

the water. Do not set the pump
directly on mud or sand surfaces.
This will cause the inlet screen to
clog.

5. The water level must be at least 1/2

inches for the pump to operate.
Water levels less than 1/2 inches will
not allow the impeller to contact
water and no water will be
pumped.

Description

This portable, submersible utility pump
is designed for non-automatic use in
water. The units are equipped with an
8 ft. 3-prong grounding type power
cord. The motor is oil filled and sealed
for cooler operation. The discharge fit-
ting is designed for convenient attach-
ment to a garden hose.

IMPORTANT: THIS PUMP IS NOT
SUITABLE FOR AQUATIC LIFE!

Unpacking

After unpacking the unit, carefully
inspect for any damage that may have
occurred during transit. Check for
loose, missing or damaged parts.

Danger indicates
an imminently haz-

ardous situation which, if not avoided,
WILL result in death or serious injury.

Warning indicates
a potentially haz-

ardous situation which, if not avoided,
COULD result in death or serious injury.

Caution indicates a
potentially haz-

ardous situation which, if not avoided,
MAY result in minor or moderate
injury.

Notice indicates

important informa-

tion, that if not followed, MAY cause
damage to equipment.

This manual contains information that
is very important to know and under-
stand. This information is provided for
SAFETY and to PREVENT EQUIPMENT
PROBLEMS. To help recognize this
information, observe the following:

1. Read these rules and

instructions carefully.
Failure to follow these
instructions could cause
serious bodily injury and/or proper-
ty damage.

Very Important Safety
Information

Advertising
This manual is related to the following products: