Worth Data RF Laser - Manual

Wireless RF Laser Bar Code Reader
QuickStart and Installation Guide
RF Laser
have to insert the original Windows® CD. The Mac always finds the driver.
In either case, the driver used is the standard keyboard driver. No special
drivers are required.
If you mistakenly abort your driver installation, see the Trouble Shooting
Section of Users Guide in PDF format on the enclosed CD.
RF Laser Reader Installation - PC Serial Port
The Base Station
can be directly
attached to a spare
serial port as shown
here using either the
F36 9 pin cable, or
the F34 25 pin
cable. This configu-
ration requires the
Worth Data F10 5v power supply for powering the Base Station. Upon
power-up, the Base Station LED will flash with 3 more flashes than the
channel setting; i.e. if it is set on Channel 0, it will flash green three times.
If the Channel were set to 7, it would flash green 10 times. See the Users
Guide available in PDF format on the enclosed CD.
RF Laser Reader Installation - Host & Terminal
If you are installing your RF Laser Reader between a dumb terminal and
host computer, please see the Users Guide available in PDF format on the
enclosed CD for installation instructions and details.
For complete setup information, please see the RF Laser Users Guide
available in PDF format on the enclosed CD.
Serial Cable
Full Users Manual available on the Utilities CD in
PDF format. You can also download the Manual and
Setup Menus at http://www.barcodehq.com
Warning: This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instruction
manual, it may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computing
device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when
operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference in which case the
user, at his own expense, will be required to take whatever measures may be required to correct the interference.
CAUTION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
LASER LIGHT WHEN OPEN
630 - 680 nm LASER • 1.0 MILLIWATT MAX OUTPUT
IEC CLASS 2 LASER PRODUCT
COMPLIES WITH US DHHS 21 CFR 1040. I0 SUBCHAPTER J
AND IEC 825-1:1993/EN60825. ACHTUNG LASERSTRAHL,
LASERKLASSE 2, NICHT IN DEN STRAHL BLICKEN.
LUMIERE LASER - NE PAS REGARDER DANS LE
FAISCEAU APPAREIL A LASER DE CLASSE 2.
WORTH DATA INC. • SANTA CRUZ, CA
manual that are laser scanners.