Yamaha MT4X - Manual (Page 14)

Controls and Connections 12
User’s Guide
Rear Panel Connections
f MONITOR OUT
connections
• Output impedance: 1 k
Ω
• Nominal output level:
-10 dB (at 10 k
Ω
load)
These RCA/Phono connectors
are used to plug in a monitor
amplifier or powered
loudspeakers. The same signal
which is output from the
PHONES connector (
d ) is also
output from these connectors.
AUX RETURN
2
L/MONO
1
L/MONO
STEREO OUT
L R
MONITOR OUT
L R
TAPE OUT
3 1 2 SYNC/4
AUX SEND
1 2
MIC/LINE INPUT
3 1 2 4
R R
g f h
i j k
g
STEREO OUT connections
• Output impedance: 1 k
Ω
• Nominal output level: -10 dB (at 10 k
Ω
load)
These RCA/Phono connectors are used to output the final stereo mixdown to the master recorder —
typically, a stereo tape deck.
h
MIC/LINE INPUT connections
• Input impedance: 10 k
Ω
• Nominal input level: -10 dB to -50 dB
These 1/4” phone connectors are used to input microphones, electronic instruments, and line-level
sources.
i AUX RETURN (1, 2) connections
• Input impedance: 10 k
Ω
• Nominal input level: -10 dB (AUX RETURN - LEVEL control nominal)
These 1/4” phone connectors are used to input the signals from external effects devices and other
signal processors. If the external device is monaural, plug it into one of the L/MONO connectors.
j
AUX SEND (1, 2) connections
• Output impedance: 1 k
Ω
• Nominal output level: -10 dB (at 10 k
Ω
load)
These 1/4” phone connectors are used to output signals to external effects devices and other signal
processors.
k
TAPE OUT (1 to 4/SYNC) connections
• Output impedance: 1 k
Ω
• Nominal output level: -10 dB (at 10 k
Ω
load)
These RCA/Phono connectors are used to output the individual tracks directly from the recorder
section of the MT4X.