Feed and pause self test, Communications diagnostics test – Zebra S4M User Manual

Page 109

Advertising
background image

103

Troubleshooting

Printer Diagnostics

10/21/05

S4M User Guide

13290L-001 Rev. A

FEED and PAUSE Self Test

Performing this self test temporarily resets the printer configuration to the factory default
values. These values are active only until power is turned off unless you save them
permanently in memory. If the factory default values are permanently saved, a media
calibration procedure must be performed.

To perform a FEED and PAUSE self test, complete these steps:

1.

Turn Off (O) the printer.

2.

Press and hold

FEED

and

PAUSE

while turning the power On (I).

3.

Hold

FEED

and

PAUSE

until the first control panel light turns off.

The printer configuration is temporarily reset to the factory default values. No labels print
at the end of this test.

Communications Diagnostics Test

Do not perform the following test until all configuration and calibration parameters have been
set. For configuration information, see

Control Panel LCD Display on page 60

.

This test is controlled from the control panel LCD display. See

Hex Dump on page 69

.

Figure 33

shows a typical printout from this test. Turn the printer power Off (

O

) and then back

On (

I

) to exit this self test and return to normal operation.

Figure 33 • Communications Diagnostics Test Label

Note •

This test label prints upside-down.

Advertising