Precautions, Important – Yamaha PW1D User Manual

Page 2

Advertising
background image

2

Precautions

• Do not place a container with liquid or small metal

objects on top of this unit. Liquid or metal objects
inside this unit are a fire and electrical shock hazard.

• Connect the power cord only to an AC outlet of the

type stated in this

Owner’s Manual

or as marked on

the power supply unit. Failure to do so is a fire and
electrical shock hazard.

• Do not locate the power supply unit in a place subject

to excessive heat or in direct sunlight. This could be a
fire hazard.

• Do not place the power supply unit in a place subject

to excessive humidity or dust. This could be a fire and
electrical shock hazard.

• Do not allow water to enter this unit or allow the unit

to become wet. Fire or electrical shock may result.

• Do not plug several devices into the same AC outlet.

This may overload the AC outlet, and could be a fire
and electrical shock hazard. It may also affect the per-
formance of some equipment.

• Do not place heavy objects on the power cord. A dam-

aged power cord is a potential fire and electrical shock
hazard.

• If the power cord is damaged (i.e., cut or a bare wire is

exposed), ask your dealer for a replacement. Using the
power supply unit in this condition is a fire and shock
hazard.

• Be sure to ground the unit to avoid the risk of electri-

cal shock

• Do not scratch, bend, twist, pull, or heat the power

cord. A damaged power cord is a fire and electrical
shock hazard.

• Do not touch the power plug with wet hands. Doing

so is a potential electrical shock hazard.

FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC

requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST

be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.

3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with

these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may
cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all
installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the
problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on
different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in
is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer
authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service
Division, 6600 Orangethorpe Ave, Buena Park, CA 90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

WARNING: THIS APPARATUS MUST BE EARTHED

IMPORTANT

THE WIRES IN THIS MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:

GREEN-AND-YELLOW : EARTH

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:

The wire which is coloured GREEN and YELLOW must be
connected to the terminal in the plug which is marked by the letter E
or by the safety earth symbol or coloured GREEN and YELLOW.

The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter L or coloured RED.

* This applies only to products distributed by YAMAHA KEMBLE

MUSIC (U.K.) LTD.

Advertising