Yamaha CRW4416S User Manual
Page 15
Chapter 2 - Installing the Yamaha CRW4416S Drive
9
3. Your hands or body may be holding a charge of static elec-
tricity. Touch a metallic portion of the chassis or power sup-
ply to release any such charge.
4. Remove the front cover of a vacant half-height drive bay.
For details refer to the manual of your computer.
5. Remove the SCSI card, and set the terminator setting of the
SCSI internal circuit to the position for internal connected
devices.
For details refer to the manual of your SCSI card.
6. Slide the CRW4416S drive into the drive bay from the front.
At this time, be careful not to apply excessive force to the drive itself.
Finger-tighten the four fastening screws, and check that there is enough
room to connect the power supply cable, SCSI cable, and AUDIO cables.
ON/
DISC
READ/
WRITE
VOL