Rear panel – Yamaha DA824 User Manual

Page 9

Advertising
background image

Rear Panel

3

DA824—Owner’s Manual

Rear Panel

A

COM port

This port is for updating the DA824’s internal firmware and is not used in normal oper-
ation.

B

WORD CLOCK THRU connector

This BNC connector transmits the wordclock signal received at the WORD CLOCK IN.

C

WORD CLOCK 75

ON/OFF switch

This switch is used to terminate the wordclock signal received at the WORD CLOCK
IN. See “Wordclocks” on page 8 for more information.

D

WORD CLOCK IN connector

This BNC connector is used to connect an external wordclock source. Normally, the
DA824 locks to a wordclock signal derived from the SLOT digital audio inputs, but
when a usable wordclock signal is present at the WORD CLOCK IN connector, this is
used instead. See “Wordclocks” on page 8 for more information.

E

OUTPUT (BAL) connectors

These male XLR-3-32 type connectors and 1/4" phone jack (TRS) connectors are the
analog outputs for each channel. Both types of connector are electronically balanced.
XLR connectors are wired as follows: pin-1 ground, pin-2 hot (+), and pin-3 cold (–).
When using both the XLR and phone jack output of a channel at the same time, ensure
that the total load is greater than 600

.

F

Power cable

This power cable is used to connect the DA824 to an AC outlet. See “Connecting the
Power Cord” on page 1 for more information.

G

SLOT

This slot is for use with optional mini YGDAI cards, which offer various digital input
options. See “Digital I/O Cards” on page 4 for more information.

SLOT

COM

THRU

75

IN

OFF ON

WORD CLOCK

DA CONVERTER
MODEL DA824

8

2

3

1

4

5

6

7

8

2

3

1

4

5

6

7

OUTPUT

(BAL)

1

5

2

4

7

6

3

Advertising