Spectrum display – Yamaha 1009MWTO-F0 User Manual

Page 41

Advertising
background image

P

anel Oper

ation and Displa

y

s

Spectrum Display

DME64N/DME24N Owner’s Manual

41

3.

Select the desired monitor point from the
list.

The audio signal from the selected monitoring point
will be output via the PHONES jack and the
[MONITOR] indicator lights up.

Probe Monitor Functions

The Probe Monitor function allows monitoring points to
be selected from the DME Designer application. For
details, see the “DME Designer Owner’s Manual.”
When the Probe Monitor function is used the monitoring
point will change and the [MONITOR] indicator will flash.

Spectrum Display

The monitor functions also provide spectrum analyzer
type level display of the signal at the selected monitor
point.

Procedure

1.

Select the monitor point for which you want
to see a spectrum display from the list.

2.

Press the [ENTER] button.

A spectrum display of the audio signal at the
selected monitor point will appear.

Frequency

These are the separate frequency bands displayed.

Band Output Level

Signal level is displayed independently in 31 separate
frequency bands. Output level is displayed in 12 steps.

Peak Hold

When the peak hold function is ON, peak levels since
the current monitor point was selected are held
indefinitely. Peak levels are cleared after one second
when peak hold is OFF.
To turn the peak hold function ON or OFF, move the
cursor to the PEAK HOLD ON/OFF setting and press the
[ENTER] button to alternately turn it ON or OFF.

L/R Select

Indicates when the spectrum display is for the left or
right channel. The same spectrum display will be shown
for the L and R channels of all monitor points other than
user-defined points specified via the DME Designer
application.
To switch between the L and R displays move the cursor
to the CHANNEL L/R setting and press the [ENTER]
button to alternately select L or R.

NOTE

Press the [CANCEL] button to move back to the previous
edit display.

NOTE

When the monitoring function is set to ON
([MONITOR] indicator lit steadily), you can turn it
OFF by pressing the [MONITOR] button.

NOTE

The monitoring point selected in the DME64N/24N is
disabled.

NOTE

Spectrum display is not available on the ICP1 control
panel.

NOTE

The fall rate of the meters can be set up via the Utility
display “Disp” page.

Advertising