Hour meter (digital type) trip meter clock, Basic components – Yamaha F250 LF250 User Manual

Page 27

Advertising
background image

Basic components

21

EMU26650

Hour meter (digital type)

This meter shows the number of hours the en-
gine has been run. It can be set to show the
total number of hours or the number of hours
for the current trip. The display can also be
turned on and off.

Changing the display format
Pressing the “

” (mode) button chang-

es the display format in the following pat-
tern:
Total hours

→Trip hours→Display off

Resetting the trip hours
Simultaneously pressing the “

” (set) and

” (mode) buttons for more than 1 sec-

ond while the trip hours are displayed re-
sets the trip counter to 0 (zero).

NOTE:

The total number of hours the engine has
been run cannot be reset.

EMU26690

Trip meter

This gauge displays the distance the boat has
traveled since the gauge was last reset.
Press the “

” (mode) button repeatedly

until the indicator on the face of the gauge
points to “

” (trip). To reset the trip meter to

zero, press the “

” (set) and “

” (mode)

buttons at the same time.

NOTE:

The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ment selected for the speedometer.

The trip distance is kept in memory by bat-
tery power. The stored data will be lost if the
battery is disconnected.

EMU26700

Clock

Press the “

” (mode) button repeatedly

until the indicator on the face of the gauge
points to “

” (time). To set the clock, be

sure the gauge is in the “

” (time) mode.

Press the “

” (set) button; the hour display

will begin blinking. Press the “

” (mode)

button until the desired hour is displayed.
Press the “

” (set) button again, the minute

display will begin blinking. Press the “

(mode) button until the desired minute is dis-
played. Press the “

” (set) button again to

start the clock.

ZMU01741

U6P212E0.book Page 21 Monday, June 6, 2005 4:23 PM

Advertising