Preparing the remote control – Yamaha RX-V2700 User Manual

Page 13

Advertising
background image

CONTROLS AND FUNCTIONS

11

En

INTR

ODUCTION

English

Installing batteries in the remote control

1

Press the

part and slide the battery

compartment cover off.

2

Insert the four supplied batteries
(AAA, LR03) according to the polarity
markings (+ and –) on the inside of the
battery compartment.

3

Slide the cover back until it snaps into place.

Installing batteries in the Zone 2/Zone 3
remote control

1

Take off the battery compartment cover.

2

Insert the two supplied batteries (AAA, LR03)
according to the polarity markings
(+ and –) on the inside of the battery
compartment.

3

Snap the battery compartment cover back
into place.

• Change all of the batteries if you notice the following

conditions:
– the operation range of the remote control decreases.
– the TRANSMIT indicator does not flash or its light becomes

dim.

• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and

manganese batteries) together. Read the packaging carefully as
these different types of batteries may have the same shape and
color.

• We recommend using alkaline batteries.
• If the batteries have leaked, dispose of them immediately. Avoid

touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment thoroughly before
installing new batteries.

• Do not throw away batteries with general house waste; dispose

of them correctly in accordance with your local regulations.

• If the remote control is without batteries for more than 2

minutes, or if exhausted batteries remain in the remote control,
the contents of the memory may be cleared. When the memory
is cleared, insert new batteries, set up the remote control code
and program any acquired functions that may have been
cleared.

Using the remote control

The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote
control sensor on this unit during operation.

• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following types

of conditions:
– places of high humidity, such as near a bath
– places of high temperatures, such as near a heater or stove
– places of extremely low temperatures
– dusty places

Preparing the remote control

1

3

2

1

3

2

Notes

Notes

30

30

Approximately 6 m

Remote control sensor

Advertising