Maintenance – hood and filter cleaning – Zephyr ZML-M90AG/AS User Manual
Page 17
15
SURFACE MAINTENANCE:
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent ,
or steel wool/scouring pads which will scratch and damage surface.
For heavier soil use liquid degreaser.
After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners, to polish and buff
out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
Do not use any product containing chlorine bleach. Do not use “orange” cleaners.
Metal Filters
The metal fi lters installed by the factory are intended to fi lter out residue and grease from cooking. They need
not be replaced on a regular basis but are required to be kept clean.
Filters should be cleaned after every 30 hours of use or once a month.
Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if
heavily soiled.
Dry fi lters and re-install before using hood.
Replacing Metal Filters
Should fi lters wear out due to age and
prolonged use, replace with following part
number:
Hood Model:
Part No.
Qty. to Order.
ZML-M90AS/AG 50200011 2
ZML-E42AS/AG 50200011 2
Replace any damaged fi lter that has punctured
or broken mesh or damaged frame.
Metal Filter Dimensions:
10 1/8in. x 12 9/16in.
253mm x 314mm
Maintenance –
Hood and Filter Cleaning