X10 Wireless Technology MS18A User Manual

X10 Wireless Technology Safety

Advertising
background image

MO

TIO

N

DE

TE

CT

OR

5-6ft

30-40ft

90˚

Now simply press the TEST button on the back of the Motion Detector (or turn the
unit over so that it sees motion). The Console will acknowledge that it has been
registered by displaying (for example) ZONE 3 SET.

Repeat this for any other Motion Detectors you want to register. The display
increments to ZONE 4 SET, etc. as you install more Motion Detectors.

Initializing Motion Detectors

Remove the cover on the front of the Motion Detector and
install 2 AA alkaline batteries in the compartment.
Replace the cover to deactivate the tamper switch.
Press and hold the TEST button on the back of the Motion
Detector for 3-4 seconds and then release it. This initializes
the Motion Detector and picks a random code that is used
when it is registered with the Console. Place the unit face
down, so that it won’t see any motion during the registering
process below.

The default PIN is 0000, so press 0000 on the keypad, or enter your PIN if you
changed it (see Security System Owner’s Manual). This clears the top line and
shows * for each number entered.

This takes you to the first level of the menu at step 1. This is the INSTALLATION
level. When you see INSTALL on the display, press OK. The display then looks like
this:

Registering the Motion Detector with the Console

Press either of the Menu Start up/down buttons (under the Console’s lid to the left of
the display). The display then shows ENTER PIN (Personal Identification Number)
in the top line.

ENTER PIN
12:00 am

****
12:00 am

1. INSTALL
ZONE

Testing the Motion Detector
• Set the slide switch on the Motion Detector to position 1.
• Press and hold the TEST button for about a second.

The LED flashes twice when you release it.

• Wait 20 seconds for the Motion Detector to settle.
• Walk in front of the Motion Detector. The indicator LED

lights each time it senses movement. Check the coverage
area and reposition the sensor as required.

• Press the TEST button to return to normal operating

mode.
Note: The Motion Detector will automatically return to
normal operating mode after about 2 minutes.

If desired, you can specify what zone you want the Motion Detector to be installed
into. Just press the number of the zone you want on the Console’s keypad, before
you press the TEST button on the back of the Motion Detector.

Press Clear to back out of the menus. You are asked to confirm, 1. YES, 2 NO.
Press 1 to go back to the HOME CONTROL screen. Press 2 to stay in the INSTALL
menu.

Installing the Motion Detector

• Attach the Motion Detector to a wall at a height of 5 to 6 ft. using the mounting

bracket and screws provided.

• Point the Motion Detector so that it looks slightly downwards.
• Set the slide switch (on the back) to position 1 for instant triggering for maximum

sensitivity, or position 2 to trigger only after two movements have been sensed.

Advertising