Yamaha MS202II - Manual (Page 3)

1
CONTENTS
Precautions .......................................................... 1
Front Panel ........................................................... 2
Rear Panel ........................................................... 3
Example Set up.................................................... 4
Specifications ....................................................... 5
Block Diagram ...................................................... 5
Dimensions .......................................................... 6
IMPORTANT NOTICE FOR
THE UNITED KINGDOM
Connecting the Plug and Cord
IMPORTANT:The wires in this mains lead are coloured in accordance
with the following code:
Blue : NEUTRAL
Brown : LIVE
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal
which is marked with the letter L or coloured RED.
Making sure that neither core is connected to the earth terminal of the
three pin plug.
Precautions
■ Warnings
1. Connect this unit’s power cord only to an AC outlet of the
type stated in this Owner’s Manual or as marked on the
unit. Failure to do so is a fire and electrical shock hazard.
2. Do not allow water to enter this unit or allow the unit to
become wet. Fire or electrical shock may result.
3. Do not place heavy objects, including this unit, on top of
the power cord. A damaged power cord is a fire and electri-
cal shock hazard. In particular, be careful not to place
heavy objects on a power cord covered by a carpet.
4. Do not place a container with liquid or small metal objects
on top of this unit. Liquid or metal objects inside this unit
are a fire and electrical shock hazard.
5. Do not remove the unit’s cover. You could receive an elec-
trical shock. If you think internal inspection, maintenance,
or repair is necessary, contact your dealer.
6. Do not modify the unit. Doing so is a fire and electrical
shock hazard.
7. If lightning begins to occur, turn off the power switch of the
unit as soon as possible, and unplug the power cable plug
from the electrical outlet.
If there is a possibility of lightning, do not touch the power
cable plug if it is still connected. Doing so may be an elec-
trical shock hazard.
8. If the power cord is damaged (i.e., cut or a bare wire is
exposed), ask your dealer for a replacement. Using the unit
with a damaged power cord is a fire and electrical shock
hazard.
9. If you notice any abnormality, such as smoke, odor, or
noise, or if a foreign object or liquid gets inside the unit,
turn it off immediately. Remove the power cord from the AC
outlet. Consult your dealer for repair. Using the unit in this
condition is a fire and electrical shock hazard.
10.Should this unit be dropped or the cabinet be damaged,
turn the power switch off, remove the power plug from the
AC outlet, and contact your dealer. If you continue using
the unit without heeding this instruction, fire or electrical
shock may result.
■ Cautions
1. Keep this unit away from the following locations:
Locations exposed to oil splashes or steam, such as near
cooking stoves, humidifiers, etc.
Unstable surfaces, such as a wobbly table or slope.
Locations exposed to excessive heat, such as inside a car
with all the windows closed, or places that receive direct
sunlight.
Locations subject to excessive humidity or dust accumula-
tion.
2. Do not place the power cord close to a heater. It may melt,
causing fire or electrical shock.
3. Hold the power cord plug when disconnecting it from an AC
outlet. Never pull the cord. A damaged power cord is a
potential fire and electrical shock hazard.
Do not touch the power plug with wet hands. Doing so is a
potential electrical shock hazard.
4. Use extreme caution when using a speaker stand and
speaker bracket.
5. To relocate the unit, turn the power switch off, remove the
power plug from the AC outlet, and remove all connecting
cables. Damaged cables may cause fire or electrical shock.
6. Turn off all musical instruments, audio equipment, and
speakers when connecting to this unit. Use the correct con-
necting cables and connect as specified.
Always lower the volume control to minimum before turning
on the power to this unit. A sudden blast of sound may
damage your hearing.
7. Do not output distorted sounds for long periods of time, as this
will cause the speaker to heat up, leading to a fire hazard.
8. If you know you will not use this unit for a long period of
time, such as when going on vacation, remove the power
plug from the AC outlet. Leaving it connected is a potential
fire hazard.
9. To prevent electrical shock when cleaning the unit, remove
the power plug from the AC outlet.
10.To allow for the efficient release of heat, maintain a gap of
10 cm or more between the rear of the MS202 II and the
wall in addition to a gap of 20 cm or more between the top
of the MS202
II and the ceiling. Locate the MS202 II away
from other equipment. If the release of heat is insufficient,
the heat will remain inside the device, and result in a fire.