Step 1: connecting this unit – Yamaha PJP-100H User Manual
Page 13
Preparation Procedure
9
PRE
P
ARA
T
ION
English
Follow the procedure below to connect this unit to the network, and then connect the AC adapter.
1
Using a LAN cable, connect the LAN port of
this unit to the network.
2
Connect the AC adapter to the DC IN 12V
terminal.
3
Connect the power cable to the AC adapter.
4
Connect the power cable to the AC outlet.
This unit is turned on and the microphone indicators
light up in sequence.
■ Standby mode
Pressing and holding
(Disconnect) for 3 seconds sets
this unit to the standby mode. In the standby mode,
“STANDBY” is displayed on the screen of this unit.
To exit the standby mode and switch this
unit on again:
Press any key.
Step 1: Connecting this unit
1
2
3
4
To AC wall outlet
01EN_00_PJP-100H_UCGB.book Page 9 Wednesday, August 23, 2006 3:04 PM