Zanussi ZWD 1270 S - Manual (Page 7)

7
• Drain only
- Press the “Skip/Reset” button once, so as to cause
the “Drain” light to light up, then press the
“Start/Pause” button.
Important! If you accidentally press the “Start/Pause”
button more than once, the display will show three
blinking dashes. To cause the washing machine to
drain the water, select any washing programme by
means of the “Fabric” button, then press
“Skip/Reset” three times in order to select the
“Drain” position (only the “Drain” light will remain
lit).
The Rinse Hold option cannot be selected for the
automatic WASHING & DRYING programme.
6 OPTIONS button
Press this button to select the following options:
• Prewash: select this option if you wish your laundry
to be prewashed before the main wash (not available
for wool and hand-wash cycle).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
40° AA: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C or higher.
If you select 40°C together with option 40 AA, the
machine will prolong the time at 40°C in the washing
phase. On cotton programme this will allow an A class
in energy efficiency and washing performance to be
achieved.
If you select 95°C, 60°C or 50°C and press the 40 AA
button, the washing temperature will be reduced and
the washing time will be prolonged.
• “ Extra Quick”: select this option for laundry that is
only slightly soiled (not for wool and Hand Wash
programme).
The washing time will be reduced according to the
type of fabric and the selected temperature.
The “Prewash”, the “40 AA” and “Extra Quick” options
cannot be selected together.
7 “Auto Dry” button
This button allows you to choose the required degree of
drying for cottons and synthetics:
- Extra dry (only for cottons)
- Store dry (cottons and synthetics)
- Iron dry (only for cottons)
The drying time is automatically adjusted by the
machine: the laundry will be dried to the selected degree
of dryness.
8 “Drying Time” button
By depressing this button you can select a timed
programme for cotton or synthetics, the relevant light
illuminates. To select “cottons” you have to push the
button for about 2 seconds. To select the drying time
push the button until the time you want appears in the
display according to the fabrics (cotton or synthetics)
you have to dry.
- For COTTON you can select a drying time from 10
minutes to 130 minutes ( 2.10 ).
- For SYNTHETICS you can select a drying time from
10 minutes to 100 minutes ( 1.40 ).
Every time you press the button the time increases by
5 mins.
9 Display
The following pieces of information are shown on the
display:
• Three blinking dashes, when a programme is
cancelled by means of the “Skip/Reset” button.
The three blinking dashes will also appear when you
press the “On/Off” button to switch the machine on, if
the previously selected cycle has been erased.
---