Installation, Before installing this unit, Installing this unit – Yamaha Digital Sound Projector YSP-1000 User Manual

Page 13

Advertising
background image

INSTALLATION

11

PREP

ARA

TION

English

This section describes a suitable installation location to install the unit using a metal wall bracket, a rack or a stand.

This unit creates surround sound by reflecting projected
sound beams off the walls of your listening room. The
surround sound effects produced by this unit may not be
sufficient when the unit is installed in the following
locations.
• Rooms with surfaces inadequate for reflecting sound

beams

• Rooms with acoustically absorbent surfaces
• Rooms with measurements outside the following range

W (3 to 7 m) x H (2 to 3.5 m) x D (3 to 7 m)

• Rooms with less than 2 m from the listening position to

the speaker positions

• Rooms where objects such as furniture are likely to

obstruct the path of sound beams

• Rooms where the listening position is close to the walls
• Rooms where the listening position is not in front of

this unit

Make sure you leave an adequate amount of ventilation
space so that heat can escape. Make at least 5 cm of space
above or below this unit.

• This unit weighs 13.0 kg. Be sure to install this unit where it

will not fall subject to vibrations, such as from an earthquake,
and where it is out of the reach of children.

• When using a cathode-ray tube (CRT) TV, do not install this

unit directly above your TV.

• This unit is shielded against magnetic rays. However, if the

picture on your TV screen becomes blurred or distorted, we
recommend moving the speakers away from your TV.

Install this unit where there are no obstacles such as
furniture obstructing the path of sound beams. Otherwise,
the desired surround sound effects may not be achieved.
You may install this unit in parallel with the wall or in the
corner.

Parallel installation

Install this unit in the exact center of the wall when it is
measured from the left and right corners.

Corner installation

Install this unit in the corner at a 40º to 50º angle from the
adjacent walls.

y

The availability of the beam mode depends on the installation
location of this unit (see page 42). All five beam modes are
available for the parallel installation whereas the 3 beam and 5
beam modes are not available for the corner installation.

INSTALLATION

Before installing this unit

Notes

5 cm or more

Rear

Front

Side view

Side

Installing this unit

An object, such as furniture

40° to 50°

An object, such as furniture

Advertising