Beam mode – Yamaha Digital Sound Projector YSP-1000 User Manual
Page 44
BEAM MODE
42
You can change the beam mode to suit the input source of this unit using the beam mode buttons on the remote control
(STEREO, 3BEAM, 5BEAM, ST+3BEAM or TARGET). Select stereo mode for 2-channel sources, 3 beam mode, 5
beam mode and stereo plus 3 beam mode for 5.1-channel playback.
All the beam modes are available in the following cases:
• If you selected Parallel to Wall for INSTALLING in AUTO SETUP (see page 33)
• If you selected settings other than CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC
SETUP (see page 64)
• If you selected FLAT TO WALL for INSTALLED POSITION in MANUAL SETUP (see page 70)
Only stereo, stereo plus 3 beam and target modes are available in the following cases:
• If you selected Angle to Wall or corner for INSTALLING in AUTO SETUP (see page 33)
• If you selected CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 64)
• If you selected ANGLE TO WALL OR CORNER for INSTALLED POSITION in MANUAL SETUP (see page 70)
Yes: the corresponding beam mode is available.
No: the corresponding beam mode is not available.
BEAM MODE
Beam
mode
AUTO SETUP
BASIC SETUP
MANUAL SETUP
INSTALLING
(see page 33)
INSTALLED POSITION
(see page 64)
INSTALLED POSITION
(see page 70)
Parallel to
Wall
Angle to Wall
or corner
CORNER
RIGHT
or
CORNER
LEFT
Other settings
FLAT TO
WALL
ANGLE TO
WALL OR
CORNER
STEREO
Yes
Yes
Yes
Yes
Yes
Yes
3BEAM
Yes
No
No
Yes
Yes
No
5BEAM
Yes
No
No
Yes
Yes
No
ST+3BEAM
Yes
Yes
Yes
Yes
Yes
Yes
TARGET
Yes
Yes
Yes
Yes
Yes
Yes
Note