Yamaha Digital Sound Projector YSP-1000 - Manual (Page 70)

MANUAL SETUP
68
To achieve the best quality surround sound, you can use MANUAL SETUP to fine-tune the listening environment
parameters, as well as to make advanced settings for speaker positions, sound beams, digital input and the OSD. Change
the initial settings (indicated in bold under each parameter) to reflect the needs of your own listening environment.
y
• You can save the settings optimized by the AUTO SETUP procedure (see page 36). A set of settings optimized according to specific
conditions of your listening environment can be recalled later depending on the varying conditions of your listening environment (see
page 37).
• Most of the parameters in SOUND MENU and BEAM MENU are automatically set when you run AUTO SETUP (see page 28). Use
SOUND MENU and BEAM MENU to make additional adjustmen ts.
• BEAM MENU allows you to make settings for the surround sound effects normally available in the speaker settings menu.
• Make settings for the parameters in BEAM MENU first before you make settings for the parameters in SOUND MENU, INPUT
MENU and DISPLAY MENU.
SOUND MENU
Use to manually adjust various parameters related to the sound output.
BEAM MENU
Use to manually adjust various parameters related to the sound beam output.
INPUT MENU
Use to manually adjust various parameters related to the audio and video input.
DISPLAY MENU
Use to manually adjust various parameters related to the display.
MANUAL SETUP
Item Features Page
TONE CONTROL Adjusts the output level of high-frequency or low-frequency sound. 74
BEAM LEVEL Adjusts the output level of each beam. 75
SUBWOOFER SET Adjusts the various subwoofer settings. 75
MUTE LEVEL Adjusts the muting level. 76
AUDIO DELAY Adjusts audio delay. 76
ROOM EQ Adjusts the tonal quality of the listening room. 76
DD/DTS Dynamic Range Adjusts the dynamic range of Dolby Digital or DTS signals. 76
Item Features Page
SETTING PARAMETERS Adjusts listening room and listening position settings. 70
BEAM ADJUSTMENT Adjusts various beam settings. 71
IMAGE LOCATION Adjusts the position of the front left and right speakers. 74
Item Features Page
INPUT ASSIGNMENT Assigns jacks according to the component to be used. 77
INPUT MODE Selects the initial input of the source. 77
INPUT TRIM Adjusts the input level of the source. 78
INPUT RENAME Renames the displayed input source. 78
Item Features Page
DIMMER SET Adjusts the brightness of the display. 79
OSD SET Adjusts the display position and the background color of the OSD. 79
UNIT SET Changes the display unit of measurement. 79