Yamaha Digital Sound Projector YSP-1000 - Manual (Page 74)

72
MANUAL SETUP
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of beams for each
speaker. By adjusting the horizontal angle of the beams,
you can optimize the sound beam paths. A test tone is
automatically output.
Choices: L90° to R90°
Adjust towards L (left) to move the direction of the output
to the left and adjust towards R (right) to move it to the
right.
VERTICAL ANGLE (Vertical angle)
Use to adjust the vertical angle of sound beams for each
speaker. By altering the beam path, you can optimize
sound beam angles.
Choices: –45° to +45°
Initial setting: 0°
• Adjust towards – (minus) to move the angle downward.
• Adjust towards + (plus) to move the angle upward.
A test tone is automatically output.
BEAM TRAVEL LENGTH (Beam travel length)
Use to set the distance that sound beams travel after being
output and reflected off the wall until they arrive at the
listening position for each speaker.
The lines in the illustration below indicate the distance.
Choices: 0.3 m to 24.0 m
• Front L adjusts the distance the front left speaker
sound beams travel.
• Front R adjusts the distance the front right speaker
sound beams travel.
• Center adjusts the distance the center speaker sound
beams travel.
• Surround L adjusts the distance the surround left
speaker sound beams travel.
• Surround R adjusts the distance the surround right
speaker sound beams travel.
Note
( )
(+)
(+)
( )
a)HORIZONTAL ANGLE 1/5
0(deg)
5 BEAM
[ ]/[ ]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
L90 R90
Front L
L60deg.
*
p p
0°
b)VERTICAL ANGLE 1/5
0deg
[ ]/[ ]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
(+)
(-)
5 BEAM
Front L
0deg.
p p
Front L ;;;;;;;7.1m
Front R ;;;;;;;7.1m
Center ;;;;;;;;3.0m
Surround L ;;;;10.0m
Surround R ;;;;10.0m
c)BEAM TRAVEL LENGTH
[ ]/[ ]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
5 BEAM
.
p p