On-screen display (osd), Osd modes, Selecting the osd mode – Yamaha RX-V800RDS User Manual

Page 22

Advertising
background image

20

ON-SCREEN DISPLAY (OSD)

Full display

Short display

You can display the operation information for this unit on
a video monitor. If you display the SET MENU and DSP
program parameter settings on a monitor, it is much easier
to see the available options and parameters than it is by
reading this information on the front panel display.

y

• If a video source is being reproduced, the OSD is

superimposed over the image.

• The OSD signal is not output to the REC OUT jack, and will

not be recorded with any video signal.

• You can set the OSD to turn on (blue background) or off when

a video source is not being reproduced (or the source
component is turned off) by using “14 DISPLAY SET” on the
SET MENU (see page 46).

OSD Modes

You can change the amount of information the OSD
shows.

Full display
This mode always shows the DSP program parameter
settings on the video monitor (see page 63).

Short display
This mode briefly shows the same contents as the front
panel display at the bottom of the screen and then
disappears.

Display off
This mode briefly shows the “DISPLAY OFF” message at
the bottom of the screen and then disappears. Afterwards,
no changes to operations appear on the monitor except
those of the ON SCREEN button.

P01 CONCERT HALL

INIT. DLY

45ms

ROOM SIZE

1.0

LIVENESS

5

P01 CONCERT HALL

y

• When you choose the full display mode, INPUT l / h,

VOLUME and some other types of operation information are
displayed at the bottom of the screen in the same format as that
for the front panel display.

• The SET MENU and test tone display appear regardless of the

OSD mode.

Selecting the OSD Mode

1

When you turn on the power, the video
monitor and front panel display show the
level of the main volume for a few seconds
and then switch to show the current DSP
program.

2

Press ON SCREEN on the remote control
repeatedly to change the display mode.
The OSD mode changes in the following order: full
display, short display, and display off.

Notes

• If you choose a video input source that has a component

connected to both the S VIDEO IN and composite VIDEO IN
jacks, and both the S VIDEO OUT and composite VIDEO
OUT jacks are connected to a video monitor, the video signal is
output to both the S VIDEO OUT and VIDEO OUT jacks.
However, the OSD is carried only on the S-video signal. If no
video signal is input, the OSD is carried on both the S-video
and composite video signals.

• If your video monitor is connected only to the COMPONENT

VIDEO jacks of this unit, the OSD is not shown. Make sure to
connect your video monitor to the COMPONENT VIDEO
jacks and either VIDEO or S VIDEO jacks if you want to see
the OSD.

• Playing back video software that has an anti-copy signal or

video signals with a lot of noise may produce unstable images.

Advertising