Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 18)

Front and Rear of Unit
10
➀ Jumper switch
Plug a plastic shunt into this jumper switch to set up SCSI ID, Parity, Terminator and
Block Size. (
→ P. 20 – 23)
➁ SCSI INTERFACE connector
Insert the connector of the SCSI ribbon cable here. ( → P. 26, 33)
➂ DC IN connector (The SCSI convertor’s side)
Insert the smaller connector of the power cable (included). ( → P. 19, 34)
➃ DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately). (
→ P. 17, 34)
➄ ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this connector, and the other end to your
computer’s sound card or built-in audio. (
→ P. 16, 34)
➅ DC INPUT connector (The CRW2200 drive’s side)
Insert the bigger connector of the power cable (included). ( → P. 19, 34)
Rear Panel (with the SCSI Convertor)
➃ ➄ ➅
➁ ➂ ➀