York SUNLINE K4EU120A50A User Manual

York Faxes

Advertising
background image

GENERAL
These completely assembled blower units are manufac-
tured under ISO 9002 Quality System Certification and
include a well-insulated cabinet, a DX cooling coil with
copper tubes and aluminum fins, an expansion valve, a
distributor, throwaway filters, a centrifugal blower, a
blower motor, a blower motor contactor, an adjustable
belt drive and a small holding charge of Refrigerant-22.
Blower motors and adjustable drives are factory-
installed on all units.

The units are shipped in the vertical position with a vertical air
discharge. The blower section can be repositioned as shown in
Figure1 for horizontal applications.

REFERENCE
Additional information for the accessories on this equip-
ment is available in the following instructions:

Electric Heater - 550.13-N10.1V

Supply Air Plenum - 550.13-N10.2V

Return Air Grille - 550.13-N10.3V

Base - 550.13-N10.4V

Hot Water & Steam Coil - 550.13-N10.7V

Renewal Parts:

Refer to Parts Manual for complete listing of replacement
parts on this equipment.

All forms may be ordered from:

Publications Distribution Center
Unitary Products Group
P.O. Box 1592, York, PA 17405

INSPECTION
As soon as a unit is received, it should be inspected for
possible damage during transit. If damage is evident, the
extent of the damage should be noted on the carrier's de-
livery receipt. A separate request for inspection by the

Installer should pay particular attention to the words:

NOTE, CAU-

TION and WARNING. Notes are intended to clarify or make the in-
stallation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury

MODELS K5EU090A50A & K4EU120A50A

(WORLD 50 HZ)

035-12122

®

INSTALLATION INSTRUCTION

SUNLINE™ SPLIT-SYSTEM

EVAPORATOR BLOWERS

(AIR COOLED)

Supersedes: Nothing

550.39-N4YI (894)

CAUTION

THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE

LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED

TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.

THIS PRO DUCT M UST BE INSTALLED IN STRICT COMPLIANCE W ITH

WARNING

OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY

O R P R O P E R T Y D A M A G E .

INCORRECT INSTALLATION MAY CREATE A CONDITION W HERE THE

Advertising
This manual is related to the following products: