Zebra 105SL - Manual (Page 83)

75 Configuration
Setup Mode
6/30/06 105SL User Guide 11342L-001 Rev. A
Exit Setup Mode
To leave Setup mode, complete these steps:
1. Press SETUP/EXIT .
The LCD displays SAVE CHANGES .
2. Press PLUS (+) or MINUS (-) to display the save options ( Table 8 ).
3. Press NEXT/SAVE to select the displayed choice.
When the configuration and calibration sequence is done,
PRINTER READY
displays.
Table 8 • Save Options When Leaving Setup Mode
LCD Description
PERMANENT Stores values in the printer even when power is turned off.
TEMPORARY Saves the changes until power is turned off.
CANCEL Cancels all changes made since you entered Setup mode,
except for changes made to the darkness and tear-off settings,
which go into effect as soon as they are made.
LOAD DEFAULTS Restores all parameters other than the network settings back to
the factory defaults. Use care when loading defaults because
you will need to reload all settings that you changed manually.
Note • Loading factory defaults causes the printer to
auto-calibrate.
LOAD LAST SAVE Loads values from the last permanent save.
DEFAULT NET Restores the wired and wireless network settings back to
factory defaults.