Yamaha TG500 - Manual (Page 157)

145
3-6-03: MIDI CONTROLLER 1 / 3-6-04: MIDI CONTROLLER
2
VOICE EDIT MODE / 3: Full Edit. 3-6: Controller
3-6-03: MIDI CONTROLLER 1 / 3-6-04: MIDI CONTROLLER 2
The parameters in these two screens set the maximum depth of modulation that
can be produced by “MC1” (MIDI Controller 1) and “MC2” (MIDI Controller 2).
VCE CTRL MC1 Depth<Amod>
(Mod.Whl.) 0 28 0é
VCE CTRL MC1 Depth<EGBs>
è(Mod.Whl.) +2 0 0
MIDI controller assignments are made via the “UTILITY” mode “2:Controller” screen
— page 223.
Amod (Amplitude modulation depth)
Range: 0 … 127
Sets the maximum depth of amplitude modulation (tremolo effects) applied
via MIDI controller 1 or 2.
A setting of “0” allows no amplitude modulation, while a setting of 127
results in maximum amplitude modulation depth.
When setting up the low-frequency oscillator to apply amplitude modula-
tion, this parameter must be set to a value other than “0” if amplitude modula-
tion is to be applied via MIDI controller 1 or 2.
Pmod (Pitch modulation depth)
Range: 0 … 127
Sets the maximum depth of pitch modulation (vibrato effects) applied via
MIDI controller 1 or 2.
A setting of “0” allows no pitch modulation, while a setting of 127 results
in maximum amplitude modulation.
When setting up the low-frequency oscillator to apply pitch modulation, this
parameter must be set to a value other than “0” if pitch modulation is to be
applied via MIDI controller 1 or 2.
Fmod
EGBs Cof
Amod
Pmod
[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]
-> [PAGE] -> 3-6-03: MIDI Ctrl 1 -> [ENTER]
-> [PAGE] -> 3-6-04: MIDI Ctrl 2 -> [ENTER]