Yamaha TG500 - Manual (Page 83)

71
3-1-10: MC3 ENABLE / 3-1-11: MC4 ENABLE
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
3-1-10: MC3 ENABLE / 3-1-11: MC4 ENABLE
MIDI control change data received by the TG500 can be used to control the level
of individual layers or specified groups of layers in the performance play mode. This
screen specifies which MIDI control device (assigned via the “UTILITY” mode
“2:Controller” screen) controls which layers.
MC3 (layer A)
PFM MC3 [A] WN Flut1
o nÿ onÿ onÿ onÿ
The layer to be edited can be selected as described on page 50. The currently
selected layer is shown in square brackets on the upper display line.
MC3 (MIDI controller 3 enable)
Range: on, off
Use the [
,] and [.] keys (or the standard layer selection procedure) to select
the layer to be edited, then use the [-1/NO] and [+1/YES] keys to turn MIDI
control of that layer on or off.
The name of the currently selected voice is shown in the upper right corner
of the display (“--------” appears if the voice is turned off). An animated musi-
cal note appears to the right of voices that are on and active (i.e. not muted).
MC4 (layer A)
PFM MC4 [A] WN Flut1
o nÿ offÿ offÿ onÿ
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-10 : MC3 Enable -> [ENTER]
3-1-11 : MC4 Enable -> [ENTER]