Yamaha TG500 - Manual (Page 86)

74
3-1-13: LAYER EXCHANGE
This function can be used to eliminate the audible effects of slight note delays
that can occur in the performance play mode. The notes played by layers A, B, C,
and D are sounded in sequence in the performance play mode. Normally the delay is
so slight that it is not audible. If a voice with a sharp attack is assigned to one of the
later layers (C or D), however, the delay can “soften” the attack of the voice. The
problem can be overcome by using this function to exchange layers A and D, for
example, so that the voice with the strong attack is assigned to layer A instead of
layer D. Since layer A is sounded first, the sharpness of the attack will be retained.
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
3-1-13: LAYER EXCHANGE
Use the [
,] and [.] keys to position the cursor, and the [-1/NO] and [+1/YES]
keys to select the layers to be exchanged (A through D), then press [ENTER] to
begin the layer exchange procedure. The following confirmation display will appear:
Press [+1/YES] again to confirm that you want to go ahead with the layer ex-
change operation, or press [-1/NO] to cancel.
“Completed!” will appear briefly on the display when the data has been ex-
changed.
PFM Exchange
Layer A †¥ A
PFM Exchange Sure?
Layer A †¥ B
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-13 :Exchange -> [ENTER]