The pedal cord all the w – Yamaha ARIUS YDP-181 User Manual

Page 60

Advertising
background image

Keyboard Stand Assembly

Owner’s Manual

60

ENGLISH

5.

Mount A.

Place your hands at least 10 cm from either end
of A when positioning it.

6.

Secure A.

6-1

Adjust the position of A so that the left and right
ends of A will project beyond D and E equally
when seen from the front.

6-2

Secure A by tightening the short screws (6 x
16mm) from the front.

7.

Connect the pedal cord and the power
cord.

7-1

Insert the pedal cord plug to the pedal connector
from the rear.

7-2

Attach the cord holders to B, then clip the cord
into the holders.

7-3

Use a vinyl tie to bundle the pedal cord.

7-4

For models that feature a voltage selector: Set the
voltage selector to an appropriate voltage.

WARNING

An improper voltage setting can cause serious damage to this
instrument or result in improper operation.

7-5

Insert the AC power cord plug into the AC
INLET.

A

E

D

At least
10 cm

At least
10 cm

A

A

6-2

6-1

Projection of A

Voltage Selector
Before connecting the AC power cord, check the setting of
the voltage selector which is provided in some areas. To
set the selector for 110V, 127V, 220V or 240V main volt-
ages, use a "minus" screwdriver to rotate the selector dial
so that the correct voltage for your region appears next to
the pointer on the panel. The voltage selector is set at
240V when the unit is initially shipped. After the proper
voltage has been selected, connect the AC power cord to
the AC INLET and an AC wall outlet. A plug adaptor may
be also provided in some areas to match the pin configura-
tion of the AC wall outlets in your area.

7-1

7-2

7-3

7-4

7-5

Advertising