Adjusting boat trim, Operation – Yamaha LF225 User Manual

Page 50

Advertising
background image

Operation

44

complete stop with the engine off. Do
not adjust the trim angle with this switch
while the boat is moving.

Adjust the outboard motor trim angle using
the power trim and tilt switch.

To raise the bow (trim-out), press the switch

” (up).

To lower the bow (trim-in), press the switch

” (down).

Make test runs with the trim set to different an-
gles to find the position that works best for
your boat and operating conditions.

EMU27911

Adjusting boat trim

When the boat is on plane, a bow-up attitude
results in less drag, greater stability and effi-
ciency. This is generally when the keel line of
the boat is up about 3 to 5 degrees. With the
bow up, the boat may have a greater tenden-
cy to steer to one side or the other. Compen-
sate for this as you steer. The trim tab can
also be adjusted to help offset this effect.
When the bow of the boat is down, it is easier
to accelerate from a standing start onto plane.

Bow Up
Too much trim-out puts the bow of the boat
too high in the water. Performance and econ-
omy are decreased because the hull of the
boat is pushing the water and there is more air
drag. Excessive trim-out can also cause the
propeller to ventilate, which reduces perfor-
mance further, and the boat may “porpoise”
(hop in the water), which could throw the op-
erator and passengers overboard.

1. Power trim and tilt switch

1. Power trim and tilt switch

1. Power trim and tilt switch

ZMU04601

DN

UP

1

U69J17E0.book Page 44 Tuesday, March 7, 2006 10:00 AM

Advertising
This manual is related to the following products: