Yamaha EMX120CD - Manual (Page 30)

E-22
To stop program play
•
Press the stop button. The first programmed track
number will be displayed.
•
To resume playback, press the play/pause / button.
Playback will begin from the beginning of the program.
To cancel a programmed sequence
There are several methods as described below.
• Press the stop button while the unit is stopped.
• Open the disc table
•
Turn this unit into the standby mode.
To check program data
1. If during playing back, press the stop button.
2. Press the PROG button.
3. Each time the
button is pressed, the track numbers
and sequential order of the programmed tracks can be
checked one after another. The display of the track
number can be returned (sequentially in reverse order) by
pressing the
button.
To correct program data
1. Follow the procedure described in “To check program
data”.
2. Display the track number to be corrected by pressing the
or button.
3. Press a track number input button to select a track to
replace the one displayed. The previously programmed
track will be cleared from the memory and the new one
will be programmed.
4. When the correction is finished, press the PROG button
or play/pause / button once again.
COMPACT DISC PLAYER OPERATION
CD CHANGER RECEIVER EMX–120CD PRESET/TUNING/BAND A/B/C/D/E
OPEN/CLOSE
DISC 1 DISC 2 DISC 3
DISC CHANGE
VOLUME INPUT SELECTOR
VCR•LD/TV•CD•TAPE/MD•TUNER
CD TUNER
STANDBY/ON
PHONES
KARAOKE
PROGRAM
MEMORY
MUSIC
DISPLAY MEMORY AUTO/MAN’L REPEAT TIME
TIME ADJ TIMER HOUR MIN
INPUT TRIM MIC TONE MIC MIC MIXING
SOFT NORMAL MAX MIN
ECHO ECHO
/
TIME
A
PROG
B C D
+ I0
E
CD TUNER
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9 0
PRESET
INPUT
MUSIC PROGRAM
STANDBY/ON
DISPLAY SLEEP
ECHO
FLAT
LEVEL KARAOKE
VOLUME
DISC SKIP STOP PLAY/PAUSE
TUNER CD
TEST
CENTER/REAR
/DELAY
OPEN/CLOSE REPEAT RANDOM MODE
PROG
/