Pioneer CDJ-500II - Manual (Page 14)

14
En
<DRB1223>
APPLICATION OPERATION
Controlling This Unit from a DJ Mixer
By connecting the CONTROL jack of this unit with the
CONTROL jack of the optional DJM-500 or DJM-300
DJ mixer, the fader starting or back cuing of the player
can be controlled from the channel fader or cross-
fader of the mixer.
For the connection and operation, read the operating
instructions of the DJM-500 or DJM-300 DJ mixer.
MOUNTING RACK
÷ When using a commercially available 19-inch
standard rack (EIA) with a sliding shelf, use the
supplied screws and spacers for mounting the player
to the sliding shelf. The player's installation surface
board of the sliding shelf should be 1.6 mm ~ 2
mm thick.
1 Make 4 holes in the commercially available sliding
shelf.
2 Place the player with top panel down and remove
the screws of the foot. (Retain all screws.)
3 Put the sliding shelf on the player with the front
panel of the player and the front side of the sliding
shelf aligned.
4 Fix the sliding shelf to the player with the supplied
screws and spacers.
1 Front side
260
30
290
4 - ø5
Unit : mm
2 3 4
Foot
Screw Supplied screw
Supplied
spacer
Caution for use of carrying case
When the CDJ-500II is used in a carrying case, be
careful for the following:
÷ During playback, use care so that the transportation
cushions do not contact the player, power cord or
audio cord; if vibration is transmitted through other
part than the feet of the product, sound skip may
occur.
|
| |
|
D
|
Also be careful not to touch the
carrying case during playback.