Yamaha DPX-1 - Manual (Page 25)

E- 22
IMAGE SIGNAL INITIAL SETUP
COLOR SYSTEM AUTO
COMPONENT
RGB PC
ENGLISH
2H.
INPUT A SIGNAL
INPUT B SIGNAL
LANGUAGE
POWER SAVING
LAMP RUNNING TIME
RESET
MEMORY1 VIDEO
OFF ON
IMAGE SIGNAL INITIAL SETUP
PRESS ”SELECT” TO RESET
LAMP RUNNING TIME ON
”YES”.
ESCAPE: EXIT MEMORY1 VIDEO
LAMP RUNNING TIME 2H. NO
YES
Menu operation
● Submenu operation—“WHITE BALANCE”
[Operation group C]
1.
Select the menu item “WHITE BALANCE” in the menu
group “IMAGE” by following steps 1—3 in “Basic
menu operation”.
The submenu mark “ ” appears on the right side of the item.
2.
Press the SELECT or + button to open the submenu.
3.
Select the submenu item by pressing the h or g
button.
IMAGE SIGNAL INITIAL SETUP
WHITE BALANCE
WHITE BOOST 0
MEMORY1 VIDEO
COLOR TEMP LOW MID-L MID HIGH
IMAGE SIGNAL INITIAL SETUP
WHITE BALANCE
CONTRAST R 100%
MEMORY1 VIDEO
CONTRAST G 100%
CONTRAST B 100%
BRIGHTNESS R 0%
BRIGHTNESS G 0%
BRIGHTNESS B 0%
ESCAPE: EXIT
4. Select the value by pressing the + or – button.
Press the RESET button to reset the parameter to the factory
setting.
5.
Press the MENU button to close the menu.
Press the ESCAPE button to return to the previous screen if
continuing to adjust settings. The – button does not close the
submenu to return to the previous screen for this parameter.
● Submenu operation—“LAMP RUNNING TIME”
[Operation group D]
1. Select the menu item “LAMP RUNNING TIME” in the
menu group “INITIAL” by following steps 1—3 in
“Basic menu operation”.
The submenu mark “ ” appears on the right side of the item.
2.
Press the SELECT or + button to open the confirma-
tion message screen.
IMAGE SIGNAL INITIAL SETUP
WHITE BALANCE
CONTRAST R 100%
MEMORY1 VIDEO
CONTRAST G 100%
CONTRAST B 100%
BRIGHTNESS R 0%
BRIGHTNESS G 0%
BRIGHTNESS B 0%
ESCAPE: EXIT
IMAGE SIGNAL INITIAL SETUP
WHITE BALANCE
CONTRAST R 100%
MEMORY1 VIDEO
CONTRAST G 100%
CONTRAST B 80%
BRIGHTNESS R 0%
BRIGHTNESS G 0%
BRIGHTNESS B 0%
ESCAPE: EXIT