Yamaha HTR-6090 - Manual (Page 120)

116
En
USING MULTI-ZONE CONFIGURATION
■ Adjusting the balance of the speaker
level in Zone 2
1
Press ZONE 2 CONTROLS on the front panel
to activate the Zone 2 control mode.
2
Press TONE CONTROL repeatedly to select
“BALANCE” and then rotate PROGRAM on
the front panel to adjust the balance of the
front left and right speaker level of the
selected zone.
■ Adjusting the tonal quality of Zone 2
1
Set the operation mode selector to AMP and
then press SELECT k repeatedly to select
“ZONE 2”.
“ZONE 2” is displayed in the display window on the
remote control.
2
Set the operation mode selector to AMP and
then press CH +/– on the remote control to
adjust the high-frequency response
(TREBLE) or TV VOL +/– to adjust the
low-frequency response (BASS) respectively.
y
You can also adjust the tonal quality of Zone 2 by using TONE
CONTROL on the front panel. For details, see “Adjusting the
tonal quality” on page 49.
Check that “ZONE 2” is displayed in the display window of the
remote control before you adjust the tonal quality of the
corresponding zone (see page 114).
ZONE 2
CONTROLS
TONE CONTROL
PROGRAM
Note
SELECT
TV
SOURCE
AMP
–
+
TV VOL
+
–
CH
TREBLE BASS
01EN_00_HTR-6090_U.book Page 116 Tuesday, June 27, 2006 6:40 PM