Yamaha HTR-6090 User Manual

Page 131

Advertising
background image

127

En

TROUBLESHOOTING

A

DDITIONA

L

INF

O

R

M

A

T

IO
N

Remote control

Problem

Cause

Remedy

See

page

The remote control
does not work or
function properly.

Wrong distance or angle.

The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.

8

Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.

Reposition this unit.

The batteries are weak.

Replace all batteries.

8

The operation mode selector is set
incorrectly.

Set the operation mode selector correctly.
When operating this unit, set it to the AMP position.
When operating the component selected by the input
selector button, set it to the SOURCE position.
When operating the TV set in the DTV or PHONO
area, set it to the TV position.

The remote control code was not correctly
set.

Set the remote control code correctly using “LIST OF
REMOTE CONTROL CODES” at the end of this
manual.

102

Try setting another code of the same manufacturer
using “LIST OF REMOTE CONTROL CODES” at
the end of this manual.

102

The library code of the remote control and
the remote control ID of this unit do not
match.

Match the remote control ID of this unit with the
corresponding remote control library code.

103, 118

Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.

Program the necessary functions independently into
the programmable buttons using the Learn feature.

104

The remote control
does not learn new
functions.

The batteries of this remote control and/or
the other remote control are too weak.

Replace the batteries.

8

The distance between the two remote
controls is too much or too little.

Place the remote controls at the proper distance.

104

The signal coding or modulation of the
other remote control is not compatible
with this remote control.

Learning is not possible.

Memory capacity is full.

Delete other unnecessary functions to make room for
the new functions.

109

01EN_00_HTR-6090_U.book Page 127 Tuesday, June 27, 2006 6:40 PM

Advertising