Yamaha HTR-6090 - Manual (Page 28)

24
En
CONNECTIONS
■ Connecting an external amplifier
This unit has more than enough power for any home use.
However, if you want to add more power to the speaker
output or if you want to use another amplifier, connect an
external amplifier to the PRE OUT jacks.
• When you make connections to the PRE OUT jacks, do not
make connections to the SPEAKERS terminals.
• The signals output at the FRONT PRE OUT and CENTER PRE
OUT jacks are affected by the TONE CONTROL settings (see
page 49).
• Each PRE OUT jack outputs the same channel signals as the
corresponding SPEAKERS terminals.
• Adjust the volume level of the subwoofer with the control on
the subwoofer (see page 50).
• Some signals may not be output at the SUBWOOFER PRE
OUT jack depending on the settings for “SPEAKER SET” (see
page 86) and “LFE/BASS OUT” (see page 86).
1 CENTER PRE OUT jack
Center channel output jack.
2 FRONT PRE OUT jacks
Front channel output jacks.
3 SURROUND PRE OUT jacks
Surround channel output jacks.
4 SURROUND BACK/PRESENCE PRE OUT
jacks
Surround back or presence channel output jacks. When
you only connect one external amplifier for the surround
back channel, connect it to the SINGLE (SB) jack.
y
• Set the “SB L/R SP” to “LRGx2”, “LRGx1”, “SMLx2” or
“SMLx1” and “PRESENCE SP” to “NONE” (see page 88) to
output the surround back channel signals at SURROUND
BACK/PRESENCE PRE OUT jacks.
• Set the “PRESENCE SP” to “YES” and “SB L/R SP” to
“NONE” (see page 88) to output the presence channel signals at
SURROUND BACK/PRESENCE PRE OUT jacks.
5 SUBWOOFER PRE OUT jack
Connect a subwoofer with a built-in amplifier.
Notes
PRE OUT
SUB
WOOFER
CENTER FRONT SURROUND
PRESENCE
SUR.BACK/
SINGLE(SB)
R
L
5
4 3 2 1
01EN_00_HTR-6090_U.book Page 24 Tuesday, June 27, 2006 6:40 PM