Yamaha HTR-6090 - Manual (Page 32)

28
En
CONNECTIONS
■ Connecting the AC power cable
Use the supplied AC cable. Do not use other AC power cables as doing so may result in fire or
electrical shock.
Plug the supplied AC power cable into the AC inlet after all other connections are complete, then plug the AC power
cable into an AC wall outlet.
■ AC OUTLETS (SWITCHED)
Use these 2 outlets to supply power to any connected
components. Connect the power cable of your other
components to these 2 outlets. Power to these 2 outlets is
supplied when this unit is turned on. However, power to
these 2 outlets is cut off when this unit is turned off. For
information on the maximum power or the total power
consumption of the components that can be connected to
these 2 outlets, see “SPECIFICATIONS” on page 136.
Connecting the power cable
CAUTION
AC IN
AC OUTLETS
To the AC wall outlet
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
01EN_00_HTR-6090_U.book Page 28 Tuesday, June 27, 2006 6:40 PM