Yamaha HTR-6090 - Manual (Page 33)

29
En
CONNECTIONS
PRE
P
ARA
T
ION
If you are to use 6 ohm speakers, set “SPEAKER
IMP.” to “6
ΩMIN” as follows BEFORE using this
unit. 4 ohm speakers can be also used as the
front speakers.
1
Make sure this unit is turned off.
See page 30 for details about turning on or off this
unit.
2
Press and hold STRAIGHT on the front panel
and then press MASTER ON/OFF inward to
the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the PROGRAM selector on the front
panel to select “SPEAKER IMP.”.
The following display appears in the front panel
display.
4
Press STRAIGHT on the front panel
repeatedly to select “6
ΩMIN”.
The following display appears in the front panel
display.
5
Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
Setting the speaker impedance
CAUTION
INPUT
VOLUME
MAIN ZONE
ZONE 2 ZONE 2 CONTROLS
ON/OFF
ENHANCER
SILENT CINEMA
NIGHT PHONES
OPTIMIZER MIC
MASTER
ON OFF
PURE DIRECT STRAIGHT
EFFECT
PROGRAM
TONE CONTROL AUDIO SELECT
INPUT
ZONE 2 ZONE 2 VOLUME
PRESET/TUNING FM/AM
SEARCH MODE EDIT
A/B/C/D/E CATEGORY PRESET/TUNING/CH MEMORY TUNINIG MODE DISPLAY
MAN'L/AUTO FM
VIDEO AUX
S VIDEO VIDEO AUDIO L R OPTICAL
INPUT
ON/OFF
2,4 3 2,5
STRAIGHT
EFFECT MASTER
While holding
down
PROGRAM
8 M I N
I M P . S P E A K E R
Note
EFFECT
6 M I N
I M P . S P E A K E R
MASTER
01EN_00_HTR-6090_U.book Page 29 Tuesday, June 27, 2006 6:40 PM