Yamaha HTR-6090 - Manual (Page 39)

35
En
AUTO SETUP
PRE
P
ARA
T
ION
11
Press ENTER to return to the top
“RESULT:EXIT” display.
12
Make sure the pointer is pointing at “SET”
and “CANCEL” and then press l / h to
select “SET” or “CANCEL”.
Choices: SET, CANCEL
• Select “SET” to confirm the “AUTO SETUP”
results.
• Select “CANCEL” to cancel the “AUTO SETUP”
results.
13
Press ENTER to confirm your selection.
The top “SET MENU” display appears in the OSD.
14
Press SET MENU to exit from “SET MENU”.
• After you have completed the “AUTO SETUP” procedure, be
sure to disconnect the optimizer microphone.
• The optimizer microphone is sensitive to heat. Keep it away
from direct sunlight and do not place it on top of this unit.
■ If an error screen appears
Press k / n / l / h to select “RETRY” or “EXIT”
and then press ENTER.
The following display is an example where “E-9:USER
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
Notes
ENTER
A-E/CAT.
PRESET/CH RESULT:EXIT
. RESULT
. SP : 5/4/0.1
. DIST: 14.0/ 17.0ft
. LVL : -9.0/ +6.5dB
SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
[
ENTER
A-E/CAT.
PRESET/CH RESULT:EXIT
RESULT
. SP : 5/4/0.1
. DIST: 14.0/ 17.0ft
. LVL : -9.0/ +6.5dB
. SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
[
ENTER
A-E/CAT.
PRESET/CH SET MENU
. ;AUTO SETUP
;MANUAL SETUP
. ;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
MENU
SRCH MODE
SET MENU
ERROR
E-9:USER CANCEL
. Don't operate
any function.
. RETRY EXIT
[ p]/[[]:Select
[ENTER]:Enter
[
01EN_00_HTR-6090_U.book Page 35 Tuesday, June 27, 2006 6:40 PM