Xantrex Technology TM500A User Manual
Tm500a
Advertising
Table of contents
Document Outline
- Table of Contents
- 1.0 INTRODUCTION
- The TM500A
- Unpacking and Inspection
- TM500A (12/24 Volt)
- TM500A - NS (12/24 Volt)
- TM48 (48 Volt)
- 2.0 INSTALLATION
- Required Tools
- Pre-Installation
- Mounting
- Surface Mounting
- Flush Mounting
- Extended Length Installations
- Deltec™ Shunt
- Mounting/Wiring the Shunt
- Mounting Circuit Board to an Existing Shunt
- Connecting the Shunt Board
- 3.0 CONFIGURATION
- Setup
- Restoring the Factory Defaults
- Setting Parameters
- Charge Efficiency
- Setting the Charge Efficiency Factor
- Amp Hours
- Setting the Amp Hours
- CHARGED Indicator Setup
- Trigger on Voltage Only
- Trigger on Voltage and Amperage
- Trigger on Voltage and Time
- Charger Considerations
- Relay Chargers
- Taper Chargers
- Three-stage Chargers
- Low-Voltage Indicator
- Configuring the Low-Voltage Alarm
- 4.0 OPERATION
- Indicators and Controls
- Buttons
- Select Button
- Reset Button
- INVERTER ON/OFF Button
- Basic Meters
- Available Meters
- % (state-of charge)
- V (Volts)
- A (AMPS)
- Ah (AMP HOURS)
- Power Saving Mode
- Data Monitors
- Reminders and Indicators
- Amp-hour Reminder
- Low-Voltage Indicator
- CHARGED Indicator
- 5.0 TROUBLESHOOTING
- 6.0 SERVICE INFORMATION
- 7.0 SPECIFICATIONS
- 8.0 WARRANTY