Yamaha DPX-530 - Manual (Page 41)

37
Important
• Some computers aren’t compatible with the projector.
• The projector's maximum resolution is 1024 × 576 pixels. It may not display images of higher resolutions than 1024 × 576
correctly.
• If the resolution and frequency of your computer aren't shown on the table, find the compatible resolution and frequency by
changing the resolution of your computer.
• Set D-SUB INPUT in the SIGNAL menu to RGB when inputting the HDTV signal as RGB signal.
• In the case of XGA, the right side of the image may not appear. In this case, adjust TRACKING in the SIGNAL menu.
• TV60 and TV50 are equivalent to 480i and 576i respectively. When these signals are input to the VIDEO or S-VIDEO signal,
the signal mode is indicated as TV60 or TV50. When they are input to the COMPONENT terminal, the signal mode is
indicated as 480i or 576i.
• This projector cannot be connected to other equipment via an RGB-CS (4 line) connection.
Connectors
SERIAL (8-pin) D-SUB (Mini D-SUB 15-pin) DVI (DVI-D 24-pin with HDCP)
Pin No. Name I / O
1 TXD IN
2 – –
3 – –
4 GND –
5 – –
6 – –
7 RXD OUT
8 – –
1
3 5
2
6 8
Pin No. Spec.
1 R(RED) / CR
2 G(GREEN) / Y
3 B(BLUE) / CB
4 GND
5 GND
6 GND
7 GND
8 GND
9 –
10 GND
11 GND
12 DDC Data
13 HD/CS
14 VD
15 DDC Clock
1 5
11
6 10
15
Pin No. Spec. Pin No. Spec.
1 DATA 2- 13 –
2 DATA 2+ 14 +5V Power
3 DATA 2 Shield 15 Ground
4 – 16 Hot Plug Detect
5 – 17 DATA 0-
6 DDC Clock 18 DATA 0+
7 DDC Data 19 DATA 0 Shield
8 – 20 –
9 DATA 1- 21 –
10 DATA 1+ 22 Clock Shield
11 DATA 1 Shield 23 Clock+
12 – 24 Clock-
17 24
16 9
8 1