Setting the manufacturer code – Yamaha AV-S70 User Manual

Page 25

Advertising
background image

23

English

REMO

TE CONTR

OL

APPENDIX

PREP

ARA

TION

OPERA

TION

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL

Setting the manufacturer code for your TV, VCR or satellite tuner/cable TV on the remote control allows you to operate the
front speaker unit and your TV, VCR or satellite tuner/cable TV by remote control. Note that there are two methods for
setting the code: manual preset and auto preset.

Notes

• Remote control of some component may not be possible depending on the model and the year of make even though its manufacturer is

listed on page i (at the end of this manual).

• Depending on the model in question, some component from other manufacturers cannot be controlled, or only limited functions can be

controlled, even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied
with the component in question.

• Setting the manufacture code can not be performed if your component to be controlled does not support remote control operation.

Setting the Manufacturer Code

Using manual preset

Transmission
indicator

1

Press the remote control selector button (TV,
VCR or SAT) for which the manufacturer code
is to be set.

The signals for controlling the front speaker unit have
already been set for the S70 button so that only the
manufacturer code for the TV, VCR or SAT needs to be
set. A manufacturer code can be set for a single button
if necessary.

2

Hold down SET and press

c

until the

transmission indicator lights.

1

2

4

3

The indicator will light.

3

While the transmission indicator is lit, use the
numeric buttons to enter the 4-digit
manufacturer code for the component to be
controlled.

The indicator will go out.

The transmission indicator will go out, the code has
been set properly. (The code has not been set properly
if the indicator flashes and then goes out.)
Refer to page i at the end of this manual for a list of
manufacturer codes.

4

Press

p

and check that the component to be

controlled turns on and off.

REMOTE CONTROL

0105AV-S70_23-30_EN

3/29/0, 4:04 PM

23

Advertising